Painted home exterior with wood trim in Katy, Texas

From the Morson Blog

Wood rot on trim: spot it early, fix it before it spreads

It usually starts at one corner of one window, where the paint bubbled and nobody had a free Saturday. Here's how to find it while it's still a small job.

By Jay Gibson, Owner, Morson Painting & Renovations · November 18, 2026 · Katy, TX

If you're reading up on wood rot repair in Katy, TX, you've probably already found the spot. It's the bottom of a window frame that feels a little soft. It's the corner of the garage trim where the paint's bubbling and the wood underneath looks dark. Out in Nottingham Country, I see the same pattern on house after house: the walls look fine from the street, but the trim's quietly going bad at the joints, and it's been going bad for a while. That's not a knock on the homeowners. Trim rot doesn't announce itself. It hides under paint that still looks decent from ten feet away, and by the time a board's crumbling in your hand, the damage has usually crept well past what you can see.

I've got over 18 years of personal painting experience, and if there's one thing that time has taught me, it's this: rot is a water problem first and a wood problem second. The wood doesn't fail on its own. Water gets in through a split caulk line or a crack in the paint, the wood stays wet longer than it can dry out, and fungus does the rest. Fix the spot without fixing how the water got in, and you'll be fixing the same corner again. So let's walk through where it hides, how you can check your own house this weekend, and what a repair that actually holds looks like.

Where rot hides on Katy homes

Start at the bottom of things. Water runs down, it pools at low points, and it sits there. The bottom rail of your window trim, the lower six inches of door frames, and the ends of fascia boards are where I find rot first, over and over. Board ends matter more than most folks realize. The end grain of a board drinks water the way a straw does, and builders don't always seal those ends before the trim goes up. Two boards meet at a corner, the caulk between them splits after a few summers of heat, and now every rain pushes water straight into raw end grain.

Garage door trim takes a beating in Nottingham Country too. The brick mold around the garage sits close to the driveway, sprinklers hit it, splash back from the concrete keeps it wet, and the bottom corners go soft while the rest of the frame still looks sharp. Porch posts are another quiet one. The base of a post can wick water up from the porch slab, and the rot works from the inside out, so the paint on the surface is the last thing to show it. Then there's the trim tucked under gutters. A gutter that overflows in a hard rain will dump water down the same stretch of fascia for months before anybody notices the stain inside the soffit.

North facing trim deserves a closer look than the rest. It doesn't get the sun that dries the south side out, so it stays damp after a rain, and damp is the whole ballgame. If your house has shaded trim under big oaks, that's where I'd start the walk.

Why our weather feeds it

Katy humidity doesn't quit. Even when it hasn't rained, the air's wet enough that a shaded board may never fully dry between storms. Add sprinkler systems that spray the house a little every other morning, mulch piled up against the bottom of siding, and shrubs planted tight against the walls so air can't move, and you've built rot a nice home. None of those things look like a problem on their own. Together, they keep wood wet, and wet wood is all the fungus needs.

Paint failure is the other door in. Paint isn't just color out here, it's the skin that keeps water off the wood. Once that skin cracks at a joint or peels at an edge, water gets behind it, and paint can actually hold moisture against the wood after the sun comes back out. That's why a small peel at a trim joint isn't a cosmetic thing in our climate. It's an open door, and it won't close itself.

The ten minute check you can do yourself

You don't need a ladder for most of this, and you don't need to be handy. Grab a flat screwdriver and walk the house on a Saturday morning, coffee in the other hand if you want. Press the tip into the wood at the places I named above: board ends, joints, the bottoms of door and window frames, the base of porch posts. Don't stab at it. Just push with steady pressure.

Sound wood pushes back. It feels firm and the tip barely marks it. Rotted wood gives. It feels spongy, the tip sinks in, and sometimes the surface paint flexes because there's nothing solid left under it. Check a few inches above and beside any soft spot too, because rot travels along the grain under paint that still looks fine. While you're out there, look for paint that's bubbling in a small patch, trim that looks swollen, caulk that's split open at the joints, and dark staining that keeps coming back after you wash the wall. Each one of those is the house telling you water's getting in somewhere.

Be honest about what you find up high. Fascia and second story trim aren't worth a risky ladder move on a weekend. Mark the low spots you can reach, take a phone photo of each one so you don't forget where they were, and let a painter with the right ladders check the rest. That's a normal part of a free estimate anyway.

Why paint alone won't save a soft board

Homeowners ask me this at the kitchen table all the time: can't you just prime it good and paint over it? No, and you should be careful with anybody who says yes. Rot isn't a stain. It's wood fiber that's already broken down. Paint sticks to the surface, and if the surface is mush, the paint's holding onto mush. It'll blister, it'll peel, and the rot underneath will keep spreading because the water path that caused it is still open. Painting over rot doesn't buy you time. It buys you a bigger repair and hides the evidence while it grows.

Waiting has a cost too, just not one I can put a number on for your house. A soft corner on one window frame can stay a one board job if you catch it now. Leave it through another wet season and the water that entered at that corner can work into the framing behind the trim, into the edge of the siding, and along the sill. The repair stops being a trim job at that point. That's the whole reason for the title of this post. Early is the difference between replacing a section of trim and opening up a wall.

What a real repair looks like

A proper repair starts with cutting, not filling. The rotted wood comes out until you're back to wood that's firm all the way through, and that sometimes means the hole gets bigger before it gets better. Don't let that scare you. A repair that stops at the first firm looking edge but leaves soft wood at the margins will fail at the margins. Once the bad wood's out, the fix depends on the size and the spot. A small, shallow area in the middle of a sound board can sometimes be built back with an exterior wood repair filler that's made to flex and take paint. Long runs, soft board ends, and rot at joints usually call for cutting out the damaged section and fitting a new piece of trim, or replacing the board outright.

The new wood needs primer on all sides before it goes up, including the back and the cut ends. That step gets skipped a lot, and it's the step that decides whether the new board lasts. Bare end grain on a replacement board will drink water just like the old one did. After the repair's in, the joints get caulked with a good exterior caulk, the whole area gets primed, and then it gets painted to match as part of the larger exterior painting work. And the water path gets fixed in the same visit: the split joint resealed, the overflowing gutter pointed out, the sprinkler head that sprays the garage trim adjusted or at least named so you can get it moved. If your painter doesn't talk about the water, he's planning to see that corner again.

Our work runs on a simple 6 step process, from the free consultation and written quote through scheduling, the repair and paint work itself, and a final walkthrough where we look at every repair together. If a job goes ahead, the 20 percent down is due by the start day and it covers materials, so the crew shows up ready. We're insured, estimates are free, and you can read the reviews behind our 5.0 rating on Google with 13 reviews before you ever call. I'd rather you check us out first. That's how a local shop should work.

Keeping it from coming back

Most of this is small stuff you can fold into a normal Saturday. Keep caulk lines at windows and doors on your list once a year, and reseal any joint that's split open. Keep mulch and soil pulled back so they aren't touching the bottom of your siding or trim. Trim shrubs back off the walls so air can move and boards can dry after a rain. Watch where your sprinklers actually land on a windy morning, not where you meant them to land. And after a big storm, glance at the gutters. Overflow lines leave a dirty streak on the fascia, and that streak is a map of where water's been pouring over.

One more thing, and I'll be plain about it: a yearly walk with a screwdriver is worth more than any product I could sell you. Ten minutes, twice a year if you're in a shaded lot, and you'll catch the next soft spot while it's still a small conversation instead of a big one.

Questions we hear in Katy

Can you paint over wood rot? No. Rot is wood that's already broken down, and paint can't make it solid again. The soft section has to come out first, then the repair gets primed and painted. Anything else is a cover up that fails.

How do I tell rot from plain peeling paint? Use the screwdriver test. Firm wood under peeling paint is a paint problem, and that's a scrape, prime and repaint fix. Wood that gives under light pressure is rot, and that's a repair problem. The two look alike from the driveway, which is why the test matters.

Does one soft spot mean the whole board has to go? Not always. A small spot caught early, with firm wood all around it, can sometimes be dug out and built back. Rot at a board end or a joint usually means cutting out that section, because that's where the water entered and the damage runs deeper than it looks.

If your walk turned up a soft corner or a bubbling patch you don't trust, call 281-505-7525 and we'll come look at it with you. I'll press the same screwdriver into the same spots, tell you plainly what's a repair and what's still sound, and leave you a written quote with no pressure attached. You can also grab a free quote online to get on the schedule, and there's more plain spoken advice like this over on the blog. We serve 27 communities around Fulshear and Katy, and Nottingham Country is home turf for us.

← More from the Morson blog · Get a free quote · Meet Jay

Found a soft spot?

Free consultation and an honest look at your trim. Call Jay at 281-505-7525 or request a quote online.

Request a Free Quote
☎ Call NowFree Quote